Notifications
Clear all
MMU3 Stuck Filament + Layer Shift after 10 minutes
I've finally assembled my MMU3 and all was well until I started printing.
1. 3,4 and 5 are quite noisy when loading and unloading filament (chugging might be the sound).
2. At each change a stuck filament message would appear, however after a purge it would start working again.
3. at the 10 minute mark there was a shuddering sound and the layer had shifted quite oddly, notably outside the boundaries of the spoil.
Any suggestions for trouble shooting?
Opublikowany : 23/10/2024 8:33 am
Topic starter
answered:
RE: MMU3 Stuck Filament + Layer Shift after 10 minutes
Second Photo
Opublikowany : 23/10/2024 8:34 am
Topic starter
answered:
RE: MMU3 Stuck Filament + Layer Shift after 10 minutes
Last Photo
Opublikowany : 23/10/2024 8:34 am
Topic starter
answered:
RE: MMU3 Stuck Filament + Layer Shift after 10 minutes
It it is an MK4 printer.
Opublikowany : 23/10/2024 10:08 am
Topic starter
answered:
RE: MMU3 Stuck Filament + Layer Shift after 10 minutes
New Error the filament is now not entering the sensor...
Opublikowany : 23/10/2024 12:39 pm
RE: MMU3 Stuck Filament + Layer Shift after 10 minutes
And the coupler is stripped yay, this is a fun project, no idea how to get another of those.
Opublikowany : 24/10/2024 3:18 pm