Idler-lever missing in the MMU3 Enclosed Full Kit?
Bought Prusa Core One and the MMU3 Enclosed Full Kit in September. I printed with the basic Coe One until now just to test it and get used to it.
Now I startet building the MMU3 and deconstructed the extruder to modify for the MMU3. In step 9D.14 it says to disassemble the Core One idle-level and to but the printed parts away. In 9D.15 you should take the Idler-level from the kit to assemble the new lever - but I can't find the part at all. Not on any bag in writing or in any bag by checking every part (put every bag in a separate container to not mix them up).
Anyone an idea where this part could be hiding or is it simply missing?
RE: Idler-lever missing in the MMU3 Enclosed Full Kit?
so after 1hour searching and frustration I went to ask my family if anyone was in my office where I have my gaming-setup and my printer... turns out someone was and 'put away' the bags 'lying around' to watch a movie on my Playstation...
End of story: Parts found - Post resolved