MMU2s on top of IKEA Lack
Hello!
I'm a dick at modeling 3D pieces, but I know there are good people at this here... 🙂
Can someone design the red piece on my scheme?
The purpose is to have the MMU2s outside the lank enclosure, bent in the front, to facilitate maintenance on MMU2s?
Big thank !
RE: MMU2s on top of IKEA Lack
I tried, never done this before.
https://www.thingiverse.com/thing:4393694
Phil
Stay safe and healthy, Phil
RE: MMU2s on top of IKEA Lack
Man, you deserve a big thank ! 🍺
RE: MMU2s on top of IKEA Lack
Let me know if you use it.
Phil
Stay safe and healthy, Phil
RE: MMU2s on top of IKEA Lack
Yes I'm going to use it 🤗 , after I finish the reprint of my MMU2s 😥
RE: MMU2s on top of IKEA Lack
Good luck,
Phil
Stay safe and healthy, Phil
RE: MMU2s on top of IKEA Lack
I put the MMU on the top, sideways. Did a large post about it here: https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-user-mods-octoprint-enclosures-nozzles-.../official-3d-printer-enclosure-from-prusa-research/paged/6/#post-138633 and there is a picture after it. I still love the easy access and it was retro-fit from a Prusa LACK enclosure v1 to support the MMU2. Still loving it.