Notifications
Clear all
Wipe Area on Top of MMU Print necessary?
Tinkering around with MMU2 and saw this unecessary line on Top of the Wipe Tower with no connection to the Tower itself in PrusaSlicer 2.0.0.
Am i doing something wrong? Is this Line necessary for anything, or is this possibly a bug in PrusaSlicer?
Thank you very much for your help.
Kind Regards,
Tom
Best Answer by richard.l:
You're not doing anything wrong and there isn't a bug in Slicer. This is the purge before the final unload at the end of the print. It should fall harmlessly down.
Publié : 19/06/2019 9:31 am
RE: Wipe Area on Top of MMU Print necessary?
You're not doing anything wrong and there isn't a bug in Slicer. This is the purge before the final unload at the end of the print. It should fall harmlessly down.
Publié : 19/06/2019 2:00 pm
n3tc0mm a aimé
Topic starter
answered:
RE: Wipe Area on Top of MMU Print necessary?
Ah... Ok, that makes sense...
Thanks a lot for your help...
Kind Regards,
Tom
Publié : 19/06/2019 2:26 pm