Notifications
Clear all
MMU2S - right button does not cause print to continue after middle button
When a load or unload fails, my understanding of what to do (after RTFM, page 37) is:
- use the left button to attempt to move the filament
- use the middle button to have the MMU do a self-check
- if it's happy, it flashes the red and green lights. press the right button to continue the print.
I have no issues doing the self-check and getting it into the "happy" state where it blinks both lights.
the right button doesn't do anything, so I can't continue the print.
please advise.
This topic was modified před 3 years by SIGSTKFLT
Napsal : 12/03/2022 5:35 am
Topic starter
answered:
RE: MMU2S - right button does not cause print to continue after middle button
my multimeter tells me the switch is dead. now to track down a new switch.
Napsal : 02/04/2022 1:59 am