MMU2s/Mk2.5s no longer supported?
I noticed in the latest 2 official releases that there is no firmware for the mk2.5s with the mmu2s. Has this support been removed? I'm still on 3.11 versions because of the hard crashes the 3.12 release was causing.
RE: MMU2s/Mk2.5s no longer supported?
I noticed in the latest 2 official releases that there is no firmware for the mk2.5s with the mmu2s. Has this support been removed? I'm still on 3.11 versions because of the hard crashes the 3.12 release was causing.
It seems that the support is removed. I also notice that
RE: MMU2s/Mk2.5s no longer supported?
Yeah I had to go all the way back to a firmware last year because the mk2.5s on the last 2 firmware revisions before this were causing watchdog timeouts if the mmu2s failed to load. Very disappointing. I've cancelled my prusa XL preorder because of this unfortunately. I just can't trust that they'll support multi systems. It took them 6 years to get m600 filament changes put in when there was a pull request in 2018 for them.