MeshMixer help - Page 2 – Hardware, firmware and software help

PJR

(@pjr)

Antient Member Moderator

RE: MeshMixer help

After doing some "research", I think this is the license plate:

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Publié : 31/05/2019 8:35 am

PJR

(@pjr)

Antient Member Moderator

RE: MeshMixer help

Sliced and viewed in the centre of the license plate:

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Publié : 31/05/2019 8:36 am

gnat a aimé

gnat

(@gnat)

Noble Member

Topic starter answered:

RE: MeshMixer help

Thanks @pjr. It would appear that I need to buckle down and figure out KISS.

MMU tips and troubleshooting

Publié : 31/05/2019 10:53 am

PJR

(@pjr)

Antient Member Moderator

RE: MeshMixer help

Been playing a bit more...

Finding this quite easy now 🙂

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Publié : 31/05/2019 11:44 am