Polski
Fora
English forum
Original Prusa i3 MMU2 & MMU2S
Hardware, firmware and software help
Flash Failed MMU2 Control device could not have been found
 
Notifications
Clear all

[Rozwiązany] Flash Failed MMU2 Control device could not have been found  

    Ostatni Post
  RSS
Sneezy
 Sneezy
(@sneezy-2)
New Member
Flash Failed MMU2 Control device could not have been found

Flashing Original Prusa MMU 2.0 Control, looking for VID/PID 0x2c99/3 or 0x2c99/4 ...
Found VID/PID 0x2c99/4 at `COM9`, rebooting the device ...
Original Prusa MMU 2.0 Control device not found after reboot
The Original Prusa MMU 2.0 Control device could not have been found

 

I have tried different cables and USB ports and no matter what I do it fails.

 

Prusa Slier 2.0 and mmuboard 1.0.5.hex

 

Thoughts?

Opublikowany : 05/06/2019 9:01 pm
Sneezy
 Sneezy
(@sneezy-2)
New Member
Topic starter answered:
RE: Flash Failed MMU2 Control device could not have been found

Anyone? Prusa is not responding to multiple emails.

We did an upgrade to a 2.5s last year and all was fine. I did the Original Prusa i3 MK2.5S/MK3S Multi Material 2S upgrade kit (MMU2S)  as advised by Prusa. I flashed the 2.5S firmware. Should I have used the 3S firmware?

Opublikowany : 21/06/2019 4:55 pm
Dave Avery
 Dave Avery
(@dave-avery)
Honorable Member
RE: Flash Failed MMU2 Control device could not have been found

hint: use the chat in the shop page not emails - make you are logged in the the shop to see the chat

Opublikowany : 21/06/2019 5:09 pm
Sneezy
 Sneezy
(@sneezy-2)
New Member
Topic starter answered:
RE: Flash Failed MMU2 Control device could not have been found

Prusa is sending me a new MMU board. I was able to get them on live chat.

Opublikowany : 21/06/2019 6:31 pm
  All forum topics
  Previous Topic
Next Topic  
Share: