Notifiche
Cancella tutti
Disable all 3 MMU Stepper motors while using a single extruder (or while printer is idle).
Well,
As reported in other posts, the motors (in my case the Idler one) can become pretty hot when the printer is idle.
Also, if doing single extruder prints while feeding the filament thru the MMU shouldn't require (in my opinion) the MMU motors to be running (?)
Therefore, isn't there any way (via GCODE ?) to stop the MMU motors when a print starts in single extrusion, or, when any print stops ?
I think this could be pretty useful 😉
Questa discussione è stata modificata 6 years fa da rud
Postato : 24/05/2019 10:23 pm
Matthias e hanno apprezzato