Benachrichtigungen
Alles löschen
Calibration Z nozzle keeps hitting the bed
Hi Team,
I am having an issue with my printer. The firmware is up to date. I run through the calibration wizard nicely but when it starts to print the nozzle hits the bed. I have tried to adjust the PINDA probe with similar results. Anyone have a suggestion.
Warm regards,
Rich
Veröffentlicht : 03/11/2018 6:55 pm
Re: Calibration Z nozzle keeps hitting the bed
you put the pinda lower? that's what I would do
I have a Prusa,therefore I research.
Veröffentlicht : 06/11/2018 3:20 am