3rd party source for Orange PTFE?
Does anyone know where to get the Orange PTFE used on the MMU2.0?
Several users and beta testers have mentioned that jamming the tube further into the head reduced jams by eliminating the transitions from tube-festo-airgap-secondPTFE.
When you do this, the orange tube is too short by ~2 cm. You can replace it with low quality PTFE (specifically warned against).
I have tried both Capricorns and the drag is much higher, the ID is smaller as well.
I have asked (and double checked) if I can get this from Prusa but they will not sell it and will not tell me where to get it. Does anyone know?
I maintain an informal list of San Diego, CA 3D printing enthusiasts. PM me for details. If you include a contact email and I can add you to the informal mailing list.