Unable to complete XYZ-calibration after MMU2s upgrade on MK3
 
Benachrichtigungen
Alles löschen

[Gelöst] Unable to complete XYZ-calibration after MMU2s upgrade on MK3  

  RSS
ZiGGstern
(@ziggstern)
New Member
Unable to complete XYZ-calibration after MMU2s upgrade on MK3

Hi

I'm scratching my head and totaly lost. After I did my upgrade from a fully working MK3 to MK3s with MMu2s a while back, I tried getting the first layer good, but failed. So i thought I'd try to reset the XYZ cal and do that again.
Now however I cant complete it. I'll go through the 4 point 12 min calibration and before i get to the 9 point measuring screen i get a Screen completely full of H-signs

H-Screen

After this the 9 point calibration starts and on the last point i go from 9 of 9 to billion of 9

Crazy points

After this, the printer just keeps counting upwards and going through the last 3 points over and over again...

I'm unable to find any other post that has this issue. Any help would be greatly appreciated. 

Regards
ZiGGstern

Veröffentlicht : 23/04/2021 9:11 pm
Teilen: