Notifications
Clear all
Unable to complete XYZ-calibration after MMU2s upgrade on MK3
Hi
I'm scratching my head and totaly lost. After I did my upgrade from a fully working MK3 to MK3s with MMu2s a while back, I tried getting the first layer good, but failed. So i thought I'd try to reset the XYZ cal and do that again.
Now however I cant complete it. I'll go through the 4 point 12 min calibration and before i get to the 9 point measuring screen i get a Screen completely full of H-signs
After this the 9 point calibration starts and on the last point i go from 9 of 9 to billion of 9
After this, the printer just keeps counting upwards and going through the last 3 points over and over again...
I'm unable to find any other post that has this issue. Any help would be greatly appreciated.
Regards
ZiGGstern
Posted : 23/04/2021 9:11 pm