Notifications
Clear all
MMU2s Extruder stepper Spinning
Just installed the MMU2S onto my MK3S. I updated the firmware on both and while I digest how I am going to set up filament feed I left the unit on. I noticed that the extruder stepper motor on the MMU2S was spinning and was getting a little hot but not bad.
Is it normal for this motor to run? Was it just looking for filament? The old configuration without the MMU didn't run the extruder motor constant.
Here is firmware for both. FIRMWARE 3.7.0 (1.0.5)
Thanks
Jeff
Posted : 15/04/2019 11:49 pm