Notifications
Clear all

MMU2S and 0.25 Nozzle Profile (not single)?  

  RSS
ScoutStorm
(@scoutstorm)
Bioluminous
MMU2S and 0.25 Nozzle Profile (not single)?

I was wondering if there were any plans to include the 0.25 nozzle into the MMU2S profiles? Currently, there is a 0.6 profile but none for the 0.25 apart from the single mode. Is this a limitation with loading/unloading different filaments with the smaller nozzle?

My goal is to be able to print multi-color parts with clear text in smaller fonts.

I have not tried making my own profile yet because I want to find out if it is even recommended first (I'm assuming not since the profile is not included).

Posted : 30/11/2019 7:27 pm
joshuapaul131129
(@joshuapaul131129)
New Member
RE: MMU2S and 0.25 Nozzle Profile (not single)?

Hello fellow Prusa Printers!

 

I'm thinking about getting an MMU after a year with the MK3(now MK3S) and my primary intent is water soluble supports and miniatures. I've seen only a few mentions of PVA at this scale and virtually no mentions of BVOH so my questions are:

 

Is it possible to print either PVA or BVOH at .05mm layer height? I think a .08 PVA was the lowest I've seen so far.

Is it possible to print either PVA or BVOH with a .25mm nozzle?

Posted : 20/01/2020 8:58 am
Share: