Notifiche
Cancella tutti

MMU 2.0S makes baby Jesus cry  

  RSS
MikiCab
(@mikicab)
Reputable Member
MMU 2.0S makes baby Jesus cry

 

It has been long hard slog to get the MMU 2.0S to work.

By far the most effective improvement was adding a magnet to the MMU Selector.

Other upgrades were Capricorn tubing 2mm ID from the buffer, Extruder Flag, Extruder Body.

MMU Selector with magnet https://www.thingiverse.com/thing:3688458

Flag  https://www.prusaprinters.org/prints/3417#_ga=2.179760108.914614693.1568993008-936818007.1536362167

Body https://www.prusaprinters.org/prints/3676#_ga=2.173451115.914614693.1568993008-936818007.1536362167

Tubing https://www.captubes.com/shop/#!/2-Meters-TL-Translucent-1-75mm-Bowden-Tubing/p/82434199/category=23214268

 

Attachment removed
Postato : 21/09/2019 6:57 pm
pruckelshaus
(@pruckelshaus)
New Member
RE: MMU 2.0S makes baby Jesus cry

It's true. It does.  I'm going to uninstall mine (that I was only able to get 1 reasonably successful print out of) and go back to a plain Mk3s. Manually swapping filament on layer changes will take less time and be less of a pain in the ass.

Postato : 21/09/2019 8:37 pm
Theion hanno apprezzato
Condividi: