Français
Forums
English forum
Original Prusa i3 MMU2 & MMU2S
General discussion, announcements and releases
MK3 accuracy with MMU2
 
Notifications
Clear all

MK3 accuracy with MMU2  

    Dernier message
  RSS
Chris Riley
 Chris Riley
(@chris-riley)
Active Member
MK3 accuracy with MMU2

Hey everyone,

Any thoughts on increasing accuracy on the MK3 when it's switch filaments? I am starting to get successful prints now using Prusa brand filament, but the layers aren't lined up like they should be. I never saw any of this before the MMU2, so I guess it could still be extrusion issues, but it kinda looks like its losing track of the hotend location while going from the purge block back to the model.

Maybe I should check that belts or re-calibrate the MK3? Anyone seeing this after the MMU2 install?

Thanks,
Chris

http://youtube.com/ChrisRiley
Publié : 26/09/2018 6:01 pm
colin.a3
 colin.a3
(@colin-a3)
Trusted Member
Re: MK3 accuracy with MMU2

Over ambitious?

Publié : 26/09/2018 6:22 pm
Chris Riley
 Chris Riley
(@chris-riley)
Active Member
Topic starter answered:
Re: MK3 accuracy with MMU2

Ha! Could be. 😀

http://youtube.com/ChrisRiley
Publié : 26/09/2018 6:27 pm
colin.a3
 colin.a3
(@colin-a3)
Trusted Member
Re: MK3 accuracy with MMU2

Those thin gray door surrounds look ambitious to me

Publié : 26/09/2018 11:32 pm
  Tous les sujets du forum
  Sujet précédent
Sujet suivant  
Partager :