Notifiche
Cancella tutti
How do you use Spool Join with MMU2?
According to the manual when using a MMU2 you should be able to have a fall over when one spool runs out such as another auto replaces it.
page 30 in this...
https://prusa3d.com/downloads/manual/prusa3d_manual_mmu2_eng_1_03.pdf
But the menu option on the LCD
LCD Menu - Settings - SpoolJoin [on/off]
Is not [on/off] but blank.
Would be nice to have this in slicer not on the LCD.
Any advice gratefully received, thanks,
Graham
Postato : 25/05/2019 4:21 pm