Notifications
Clear all
Stránka 2 / 2
Předchozí
RE: Does your MMU2.0 cutter work?
@torbjorn-j3
Thank you. Time to print.....
Napsal : 28/05/2020 3:27 am
RE: Does your MMU2.0 cutter work?
Basically i just did a CPE/VBOH small print. The cutter doesn't work on every filament change. In my case it only worked when one of the changes failed to load. After three times it cut the filament and tried again. Im one of those customers that are not especially happy with mmu2s. But with the cutter along with dribbling version of prusaslicer (thanks antimix) there is hope. My issues come from the hot summer days where is really difficult not to have bad tips. This may do the trick. i hope it doesn't get mangled up at some point.
On another note i have the dual blade mod on my mmu2s. I didn't changed it to the one suggested by prusa.
Napsal : 28/05/2020 4:28 pm
Stránka 2 / 2
Předchozí