2000 tool change mark  

Re: 2000 tool change mark

Thats tragic @toaf

Not a fail from selector trouble, missed load, bad tip etc. Would have never considered that could happen.

Re: 2000 tool change mark

after a fast look, it seems 190 is max Z for me. ill look into it more after the next print.

doesn't look like it's my fault 190 is max but I have to look closer later to make sure.

Re: 2000 tool change mark

well I had some wires sticking out that wouldn't let the extruder go above about 180/190

it looks like the filament run out raises the extruder around 20 mm or so.

anyone know how much a "crash detected" moves the extruder up?

I feel I must do science to explain why my super jedi test failed.. at least it didn't fail from filament issues

Re: 2000 tool change mark

by the way purge block weighed 1.2 pounds. at least the fail was my fault (kinda)

Re: 2000 tool change mark

And the print weighed?

Re: 2000 tool change mark

didn't even weigh it. not that much. I knew this test was gonna be a filament eater

Re: 2000 tool change mark

Yeah ¾ of a whole spool of purge is … scary

Re: 2000 tool change mark

blame the 3900 tool changes. i know i could have saved some by making the purge abit smaller.. but its ok. all about the till changes

Re: 2000 tool change mark

i printed 2 things that was over 200mm so on mine i have clearance.

Re: 2000 tool change mark

ya 100% my bad. the dumb useless filament sensor wire wasn't all the way in.

Re: 2000 tool change mark

i can tell you that as the height increases there is a concern to how the orange tube deforms in a very upwards 'U' shape and how much more friction this introduces to the unload/load cycle.

many of my tall prints happened to end with one color requiring no color changes for the last 10-20mm