Notifications
Clear all
Selector error after PTFE length adjustment
Hi,
i still tried to bring back my MK 2.5 with MMU 2.0 to life, after many disassembly and assembly of my extruder, i ran into an new error.
I flashed the firmeware 1.0.3 that works fine but after i tried to set the PTFE length, the selector didn't move in the right place e.g. to load correct F1 the selector must stand about 1mm from the left end away, but instead of that it stands complete on the left end.
To fix that i need to flash the FW again and then the PTFE length is wrong again and so it begins again.
Maybe, i am to stupid to set the length, but i guess i use the way as discribed in the manual
Publié : 05/02/2019 9:08 pm