Avisos
Vaciar todo
MMU2S Single Mode switching to filament 1 when 2 is selected
MMU2S running 1.0.5
Slicer PE 1.42 Beta
Printer asks which filamennt to select, I select #2. Calibration and Purge line done with Filament 2 as selected. However, as soon as the purge line is completed, the printer switches back to filament 1.
Any ideas?
Respondido : 26/03/2019 3:46 pm
Re: MMU2S Single Mode switching to filament 1 when 2 is selected
Having the same issue....
MK3S FW: 3.7.0-2201
MMU2S FW: 1.0.5-297
Respondido : 15/04/2019 3:17 am
Re: MMU2S Single Mode switching to filament 1 when 2 is selected
So I think I know what happened, I needed to restart Slic3r and try again, for some reason it was not clearing the T0 from the gcode.
Respondido : 15/04/2019 3:58 am
RE: MMU2S Single Mode switching to filament 1 when 2 is selected
Thanks for the follow up, I’m having the same problem. Off to check Prusaslicer.
Respondido : 18/06/2019 12:53 am