Notifications
Clear all
Is there somethin like Filament tangle detection?
Is there any way i can detect wheter my filament spool is tangled during print so it stop printing? When i carry my filament around sometimes it gets tangled and i am scared that it might damage electronics or other hardware bcs it wont stop printing.
Publié : 21/04/2024 8:46 am
RE: Is there somethin like Filament tangle detection?
Like: https://www.printables.com/model/125850-all-in-one-filament-jam-cleaner-runout-sensor ?
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Publié : 13/06/2024 2:03 pm
Juraj Rojko a aimé
Print yourself some filament clips. It's in the nature of the spooling process that the filament cannot tangle when filling the spool so all tangles are caused when loose ends of filament slip under one another. By clipping and immobilising the loose end you avoid the problem.
Cheerio,
Publié : 13/06/2024 2:19 pm
Juraj Rojko a aimé