Notifications
Clear all

how to make MMU2 to work with MK3S  

  RSS
3D Printersaur
(@3d-printersaur)
New Member
how to make MMU2 to work with MK3S

Hey I got an MMU2 not realizing i needed the MMU2S to work on my prusa MK3S. I have everything installed except the filament sensor cover doesn't fit on top of the printer head. I just wanted to see if anyone knows how to fix this and if there is anything i need software/firmware wise to make the two components work.

 

Thanks in advance!

Posted : 06/01/2020 10:18 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: how to make MMU2 to work with MK3S

As far as I remember, there are only differences in the printed parts.

The only problem is the brass insert of the cover. I see 3 options:

  • Ask the Prusa chat for the right cover or order it directly
  • Take the insert from the old cover
  • Order some fresh inserts

Take a look into the assambly manual for the ajustments.

Posted : 07/01/2020 8:58 am
kUMters
(@kumters)
Estimable Member
RE: how to make MMU2 to work with MK3S

I think there was/is an option to order upgrade pack from MMU2 to MMU2s

MK3S + MMU2S (@BMG + MOSQUITO), MINI, ANET A8

Posted : 07/01/2020 9:20 am
vintagepc
(@vintagepc)
Member
RE: how to make MMU2 to work with MK3S

If you are an MMU2 owner you should have gotten the relevant upgrade for free. Definitely contact chat. 

Posted : 07/01/2020 2:14 pm
3D Printersaur
(@3d-printersaur)
New Member
Topic starter answered:
RE: how to make MMU2 to work with MK3S

@lichtjaeger

sounds great. thanks so much for the information. I'll start looking into that right away.

Posted : 07/01/2020 3:54 pm
Share: