GETTING GOOD FILAMENT TIPS
I had a very hard time getting good filament tips in between changes. I was successful changing 4 filament settings in slicer. temperature, unloading speed at start, unloading speed, and cooling moves.
RE: GETTING GOOD FILAMENT TIPS
What did you change? Can't read the image
RE: GETTING GOOD FILAMENT TIPS
I had a very hard time getting good filament tips in between changes. I was successful changing 4 filament settings in slicer. temperature, unloading speed at start, unloading speed, and cooling moves.
Cannot even see your picture. Upload the picture for better results.
Why the concern about the filament tips on pulling them out? Use the recommended settings. If a little stringy print decrease by 5C and try again. Or use a temperature block to dial in your best temps.
RAH
I am the inveterate tinkerer. I can tink up most anything.
RE: GETTING GOOD FILAMENT TIPS
All of those filament tests are essentially wasted time and show you absolutely nothing of value.
What are you trying to do or evaluate?
RE: GETTING GOOD FILAMENT TIPS
I live in houston and its very humid here. Stringing was a huge issue of mine. Sorry for the bad picture. Simple temperature changes didnt help me. Just trying to be some help to some people who might be having the same issue.