What will be the theoretical e-steps value for the MK3S+ extruder motor if I change the gearing to HGXlite and the new motor gear has 17 teeth?

Dernier message

RSS

Mario L

(@mario-l)

Active Member

What will be the theoretical e-steps value for the MK3S+ extruder motor if I change the gearing to HGXlite and the new motor gear has 17 teeth?

What will be the theoretical e-steps value for the MK3S+ extruder motor if we replace the original filament feeding gears with a dual gear train (44:17 and 37:17) and the new filament drive wheel has a diameter of 18 mm? And will it be necessary to change the motor's rotation direction in the firmware?

Publié : 23/05/2025 9:36 pm

Statistiques du forum

585 Forums

68.4 K Sujets

478.7 K Messages

10 En-ligne

76.3 K Membres

Le dernier des messages: PTFE tube wear? Notre nouveau membre: rhn Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé