Silent part fan upgrade for Mk2, Mk3

Dernier message

RSS

dangerousdoug

(@dangerousdoug)

New Member

Silent part fan upgrade for Mk2, Mk3

Hi All, I've just upgraded my Mk2 to a 2.5S, and the difference in printing noise level is HUGE! Post upgrade the loudest noise from the printer is the part fan, when I'm printing PLA. I was so impressed by the massive reduction in fan noise when replacing the old Mk2 hotend fan with the new Noctua fan. So my question is:

is there a replacement part fan which is significantly quieter than the stock fan?

any suggestions gratefully received.

thanks

Doug

Publié : 21/10/2020 10:54 am

nacalco

(@nacalco)

New Member

RE: Silent part fan upgrade for Mk2, Mk3

Publié : 04/11/2020 11:30 am

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

20 En-ligne

67.8 K Membres

Le dernier des messages: How to interpret ‘Width’ in the legend PrusaSlicer? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé