Benachrichtigungen
Alles löschen
PSU and enclosure heater auto power off when print finished
Hello everyone,
I would like to implement the following solution:
I have an Original Prusa mk3s and lack enclosure. My plan is to implement an enclosure heater to raise the ambient temp to around 50C.
When the printer finish printing I would like to power off the heater and the printer's PSU with the BIGTREETECH relay:
So my question is, can I control the BIGTREETECH relay through the EinsyRAMBO board? Which pin can I use and how to control it with gcode?
I use an old mini pc with Ubuntu and not a RasberryPi, so for me the best option would be to directly control the relay with the Einsy with gcode, if possible.
Thank a lot in advance!
Veröffentlicht : 26/07/2021 12:56 pm