Notifications
Clear all

PrusaControl with E3D Volcano block  

  RSS
Gary Overgard
(@gary-overgard)
Active Member
PrusaControl with E3D Volcano block

I have put on a E3D Volcano block with a 1.2mm nozzle on my Prusa I3 MK3. Under PrusaControl/Settings there is a 'Printer variation' setting for the nozzle size that includes 0.25, 0.4, & 0.6mm. Is there a file I can edit to include the 1.2mm in this setting? Currently I am working with the 'materials' section in file materials_i3_mk3.json and after adding a "1.2mm PVA" section, changing the "layer_height", and all the extrusion_width parameters, but not sure this is the best way. Would I be better off switching to the slicr3 software if I am playing with these parameters?
-thanks in advance

Posted : 25/10/2018 7:07 pm
Share: