Octoprint Pause/Resume on MK2.5
Does the long pause GCODE command still work? When I pause my prints via Octoprint, my MK2.5 stops printing directly where it is on the printbed, without raising the extruder, moving the print bed forward, and turning off the extruder heater like it is supposed to when receiving the M601 gcode command.
My Octoprint settings are as follows (these have worked on the MK2S before the Linear Advance update that borked a lot of the serial communication):
After print job is paused:
M601 ; pause print
Before print job is resumed:
M602 ; Resume print
G4 P5000 ; Dwell
It seems that I get the same pause behavior with and without these GCODE scripts configured. Does anyone know how to get the desired M601 long pause behavior from Octoprint?
Re: Octoprint Pause/Resume on MK2.5
No, they broke it with the last Update.
It was working fine, but now my Filament Sensor is useless.