Need modified firmware for extended z axis mk3s
welp like the tile states. i have been searching far and wide for a modified firmware file that accommodates for a taller z axis. i purchased this clone kit
its a taller bear kit mk3s
-bear extruder
-taller z axis
that unfortunately did not come with modified firmware. the height is 400mm from the bed to the bottom of the z top bracket (if that is how the build volume is measured?)
if anyone can point me in any direction to firmware or on how to modify it i would very much appreciated. just want to get this puppy printing
thanks john
RE: Need modified firmware for extended z axis mk3s
Try here!
Zaribo downloads
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Need modified firmware for extended z axis mk3s
thanks Joan!
RE: Need modified firmware for extended z axis mk3s
Hope it helps. Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK