Avisos
Vaciar todo
Modded hot end mounting parts to conteract Pinda sag (and fan sag)
Printing ABS/ASA in a warm enclosure (32-40C), the Pinda sensor kept sagging lower and lower, adjusted it up a few times but finally decided on a better fix. Also the fan end support was sagging a bit, but not as big of a problem. Here are 2 components with braces to counteract the condition. So far they work great, the "after" photo is with approx. 24hrs warm printing.
https://www.thingiverse.com/thing:4651284
Respondido : 12/11/2020 4:35 pm
RE: Modded hot end mounting parts to conteract Pinda sag (and fan sag)
I will give it a try. Thanks.
--------------------
Chuck H
3D Printer Review Blog
Respondido : 22/11/2020 3:14 am