Modded hot end mounting parts to conteract Pinda sag (and fan sag)
 
Notifications
Clear all

Modded hot end mounting parts to conteract Pinda sag (and fan sag)  

  RSS
useruser55
(@useruser55)
New Member
Modded hot end mounting parts to conteract Pinda sag (and fan sag)

Printing ABS/ASA in a warm enclosure (32-40C), the Pinda sensor kept sagging lower and lower, adjusted it up a few times but finally decided on a better fix. Also the fan end support was sagging a bit, but not as big of a problem. Here are 2 components with braces to counteract the condition. So far they work great, the "after" photo is with approx. 24hrs warm printing.

https://www.thingiverse.com/thing:4651284

 

 

Napsal : 12/11/2020 4:35 pm
cwbullet
(@cwbullet)
Member
RE: Modded hot end mounting parts to conteract Pinda sag (and fan sag)

I will give it a try.  Thanks.  

--------------------
Chuck H
3D Printer Review Blog

Napsal : 22/11/2020 3:14 am
Share: