Notifications
Clear all
Manual nozzle temperature restart prusa
I think was my problem, but cannot figure out what i did wrong. Got used Prusa, and want to change nozzle, since prints was not best one. I think when i hold nozzle holder i did short circuit, since in manual is writtnen i need to preheat it over settings over 280°, what i did.
But now when i try to preheat nozle, prusa simple restart. Now i am stuck, what to do ;)?
Posted : 01/10/2025 4:06 pm
Please supply a picture of the point where the wires join the hotend.
Cheerio,
Posted : 01/10/2025 7:42 pm