Looking for MK3 testers for Y belt holder

Dernier message

RSS

zbrozek

(@zbrozek)

Trusted Member

Looking for MK3 testers for Y belt holder

I don't have a MK52 bed, but I designed a different Y belt holder. It's part of the collection posted here, but I've also just attached the relevant STL.

Major changes from the stock part:

Puts the belt line in-line with the 16T pulley on the motor.

Improves the belt profile to match the official GT2 line.

Stiffens the part in torsion.

Changes the belt retention to a bar clamp with screw. It's much easier to get it off without damaging the belt. I think it also retains the belt better.

Publié : 10/07/2018 7:30 pm

Statistiques du forum

565 Forums

63.6 K Sujets

446 K Messages

21 En-ligne

68.9 K Membres

Le dernier des messages: Slicer 2.9 Bug? Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé