Notifications
Clear all
Full bear upgrade speed tuning
Hi all, I've recently upgraded to a full bear, and looking at dramatically increasing the speed, however I'm not really sure what values to tinker with, as a lot of websites (teaching tech) refer to a flow rate.
So far I've done a few of the teaching tech external perimeter speed tests, and was able to hit 200mm/s, however I cannot seem to override the machine limits using M203 commands to go any faster using the gcode generator. However I really don't think I can just change all the values to 200mm/s.
I used these settings, and got a really nice benchy in 1h18m.
Are there any other calibration tools/tests I can use to fine tune my speed, or does anyone have any values I could use as a starting point?
Opublikowany : 26/01/2023 1:03 am