PrusaSlicer is scaling down my model automatically
 
Avisos
Vaciar todo

[Cerrado] PrusaSlicer is scaling down my model automatically  

  RSS
Accutech
(@accutech)
New Member
PrusaSlicer is scaling down my model automatically

I have successfully printed over a dozen models but for some reason this simple flange bushing model is scaled down (approx. 1/50th) when loaded into PrusaSlicer.

I have re-created the SolidWorks model in mm and inch but nothing is working. Is there a setting that I need to look at? 

Thanks,

Respondido : 18/02/2020 1:34 pm
Accutech
(@accutech)
New Member
Topic starter answered:
RE: PrusaSlicer is scaling down my model automatically - photo attached of what I am getting...

Respondido : 18/02/2020 10:26 pm
--
 --
(@)
Illustrious Member
RE: PrusaSlicer is scaling down my model automatically

Look for a point that is off centered.  Any small bit (point, vertex, object) way out there in your drawing will cause slicer to scale - even if it's not really a shell.

Esta publicación ha sido modificada el hace 4 years por --
Respondido : 24/02/2020 8:41 am
Compartir: