Octoprint not heating up MK2S
After postponing my enclosure for a good half a year, it was time that I went back to it, but before I wanted to continue I wanted to get Octoprint on my Raspberry Pi 3 working beforehand.
So off I go and install OctoPi and so far so good, I can connect to the MK2S (running FW 3.1.0), I can stop prints, check the temperatures that are still going, upload files, and set them to print.
This is where the issue lies and that's starting the print. When I hit print I expect the temperatures to rise on both the nozzle and the bed, but instead the Target is always set to "off". I manually set them to something higher and immediately they revert back to "off". Is there something that I have not set in Octoprint that's forcing this issue, or is there an explanation why this is happening?
I've been at it for a couple days now including browsing the web and I can't find anything about it.