Notifiche
Cancella tutti

[Chiuso] X-axis shift during the printing  

  RSS
wei.t
(@wei-t)
New Member
X-axis shift during the printing

My X axis seems like it shift during the printing and shift it back later. It has been like this lately. It was printing fine before. Tried to tighten the two screws on the X axis, doesnt seem helping.

Any idea?

Thanks

Postato : 14/09/2017 7:51 am
henrik.w
(@henrik-w)
Estimable Member
Re: X-axis shift during the printing

Hello Wei!

Here is a starter for the problem http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/-before-you-ask-troubleshooting-video-updated--t472.html . Search for "Print suddenly shifts in X or Y and keeps printing" in the post. If the problem persists after checking the possible causes named in the post, then we are ready to take it from there.

/Henrik

Postato : 14/09/2017 9:14 am
jevin.k
(@jevin-k)
New Member
Re: X-axis shift during the printing

I had the same issue. I had a tiny screw fall out of the X axis motor's GT2-16 pulley. There should be 2 screws in there.
Image of pulley:
https://imgur.com/40YmiLI

Postato : 14/08/2018 12:55 am
Condividi: