Notifications
Clear all

X-Axis Motor Belt Alignment  

  RSS
michael.b68
(@michael-b68)
New Member
X-Axis Motor Belt Alignment

I just finished building my MK2S kit and noticed the belt was twisted a bit coming from the X-Axis motor. I saw that the problem was the pulley wasn't aligned with the x-carriage, but I can't move the pulley into a position that it will be. I'm not sure what adjustment I could make except for putting spacers on the motor. After searching I found some people had a similar issue with the idler, but I haven't seen anyone else with this issue. Can anyone offer some advise on how to fix this?

Posted : 25/12/2017 8:01 pm
lee.g
(@lee-g)
Estimable Member
Re: X-Axis Motor Belt Alignment

Put the pulley onto the shaft the other way. I.E. The grub screw side must be on the outside of the belt.

Posted : 25/12/2017 8:40 pm
michael.b68
(@michael-b68)
New Member
Topic starter answered:
Re: X-Axis Motor Belt Alignment

That was it! I went back and checked the assembly instructions and don't know how I missed it....twice. Thank you so much and Merry Christmas. 😀

Posted : 25/12/2017 9:46 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: X-Axis Motor Belt Alignment

Might be time to get some spare GT2 belt for the future

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 25/12/2017 11:19 pm
Share: