Notifications
Clear all
Tiny blobs in ABS?
New roll of filament suddenly extruded like this. Extrusion temperature change on the fly seems to have no effect. Anyone seen this before?
Used fast setting 0.3mm Prusa profile for Simplify3D
MK2
Publié : 28/07/2016 6:43 am
Re: Tiny blobs in ABS?
Janis
AKAIK, your extrusion width (for the outside at least) should be between nozzle width and nozzle width + 25%.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Publié : 28/07/2016 9:20 am