Notifiche
Cancella tutti
The Printers 3D Printed parts question
I have got my Pi3 up and running (apart from some bed levelling issues - will make a new thread about these) and want to print some spare parts but have some questions.
1) What should I print them in PLA or ABS?
2) Is it correct that the thinner the layers the stronger the finished part?
3) Is there anything special to take into consideration?
Hope someone can help!
Postato : 17/11/2015 10:57 pm
Re: The Printers 3D Printed parts question
I have personally printed them in ABS with 0,2 layer height . And used 20% infill in some of them the extruder parts were solid . And print multiple parts at once. Some small places might get hot and bend upwards or look ugly when you print with ABS.
Postato : 17/11/2015 11:13 pm