Notifiche
Cancella tutti

Self calibration  

  RSS
Ed
 Ed
(@ed-14)
New Member
Self calibration

When I do a self calibration test , left hot end spinning and then it said not spinning left hot end fan wiring error but the fan that's not working is the bed fan that cools the filament and the hot end is working, I can turn on the bed fan in the temp settings ,it's got me going nuts.

extruder temp not reading right, the extruder get very hot and the filament starts to smoke it's so hot and I check the thermistor and it's reading the temp when I pull it out and put some heat to it

the printer work great ,the self levelling ,the end stops just the extruder and the one fan that's not working right

Postato : 10/07/2017 6:44 pm
Condividi: