Notifications
Clear all
Replacing spool on the fly
Hello Men,
I've tried to search about this matter on the forum without success.
I'm wondering if there is a proper method to change the spool when the filament is finishing without compromising the current print job... probably a silly question 😳
Thank you.
Napsal : 25/06/2016 8:17 pm
Re: Replacing spool on the fly
Yeah, it's quite simple really, use the "Change Filament" option - I think when the printer is working it is under the "Tune" option.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Napsal : 25/06/2016 11:00 pm
Topic starter
answered:
Re: Replacing spool on the fly
Thank you Peter,
I'm nearly ready to face with the spool change for the first time....hope to not mess everything 😳
ciao
Napsal : 25/06/2016 11:30 pm