Rate my first print
Hi there,
After some calibration I printed my first test in PLA.
Can you let me know if the quality is okay? Any settings I should adjust? The bottom part looks nice, the front looks a little messy but maybe that's the way it should be.
I didn't mess with any settings yet except the "Live Z-adjust".
Re: Rate my first print
looks good for me. the front looks "that messy".
maybe you could "squish" the first layer a little bit more... but it's allright the way it is now.
dem inscheniör is' nix zu schwör...
Re: Rate my first print
My thoughts were that it may be over-extruding a tad, maybe 2% reduction in flow, and as Jeff says, lower Live Z a little.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…