Quieter printer - NEW FW

Page 2 / 2 Précédent

Dernier message

RSS

erron.w

(@erron-w)

Estimable Member

Re: Quieter printer - NEW FW

I'm assuming my new printer (purchased just a few days ago) contains the updated firmware? Or will i need to update it?

Publié : 26/11/2015 9:05 pm

Josef Průša

(@josef-prusa)

Membre Admin

Topic starter answered:

Re: Quieter printer - NEW FW

Hi, yes it should 🙂 You can check in the support menu option on your LCD.

Founder and owner / Majitel a zakladatel

Publié : 30/11/2015 5:17 pm

nisan.b

(@nisan-b)

New Member

Re: Quieter printer - NEW FW

will this work on an Arduino / RAMPS combo?

thanks

Publié : 07/01/2016 1:39 pm

PJR

(@pjr)

Antient Member Moderator

Re: Quieter printer - NEW FW

No, not unless you are willing to make a whole load of changes to the firmware first.

Why not just download the original Marlin firmware which will work on RAMPs and change that to your requirements?

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Publié : 07/01/2016 1:45 pm

Page 2 / 2 Précédent

Statistiques du forum

559 Forums

62.8 K Sujets

442.5 K Messages

20 En-ligne

67.5 K Membres

Le dernier des messages: Really big difference in print between MK4 and MK4S why? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé