Notifications
Clear all

Prusa i3 1.5 Rework not really auto leveling  

  RSS
g.t
 g.t
(@g-t)
New Member
Prusa i3 1.5 Rework not really auto leveling

Hi All,

I'm already using my printer for a half year but my auto leveling is not really auto leveling and want some help if possible.

When I do a G29 all works fine and printer is checking 4 points and showing me the Z axis offset for the hits/checks 4 points. I use a inductive sensor.

I'm thinking that even the bed is not 100% even the auto leveling will fix this difference but when printing some places of the bed is printing well but other places it's just drops the plastic. Can somebody tell my how I can configure that Z axis auto correct the little difference?

I'm using the Marlin_Prusa_i3_rework_1.5.zip firmware which can be found on reprap-3d website.

Does maybe somebody now how to fix this ?

Thanks in advance,

Topcu

Publié : 27/09/2016 5:39 pm
Ben
 Ben
(@ben)
Reputable Member
Re: Prusa i3 1.5 Rework not really auto leveling

Is this a Prusa original or a reprap?

Publié : 27/09/2016 5:53 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Prusa i3 1.5 Rework not really auto leveling

This is a clone "rework" and nothing to do with Josef's original Prusa i3.

Topcu, unfortunately, you will have to ask your printer supplier and/or manufacturer about your problem, as this forum is only for the Prusa Original printers.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Publié : 27/09/2016 9:22 pm
Ben
 Ben
(@ben)
Reputable Member
Re: Prusa i3 1.5 Rework not really auto leveling

g.t

Have a wonder over and ask here. Tons of helpful people on there that know their stuff when it comes to reprap. Hopefully you get your problems sorted 😉

http://forums.reprap.org/

Publié : 27/09/2016 10:19 pm
christophe.p
(@christophe-p)
Membre Moderator
Re: Prusa i3 1.5 Rework not really auto leveling

Hi Topcu,

This printer is manufactured by eMotion Tech, a french company.

This forum is dedicated to the PrusaResearch printers. Even if the base architecture is the same, the implementations differs, so you won't have many help in your situation, sorry.

You can try the official support page https://www.reprap-france.com/support or the forum linked by Ben.

I'm like Jon Snow, I know nothing.

Publié : 28/09/2016 9:19 am
g.t
 g.t
(@g-t)
New Member
Topic starter answered:
Re: Prusa i3 1.5 Rework not really auto leveling

hi all,

Sorry, I thought this was the place.

Thanks for the replies.

Publié : 28/09/2016 10:28 am
Partager :