Notifications
Clear all
Prints failing
I have been trying to run the vcode calibration but keep getting this problem, see photo.
The print looks pretty flat, I have tried lowering the z axis even more, but then the print is completely flat.
What should I be doing?
I have a 0.5mm nozzle.
temps 210/55.
Thanks for helping me. I am only 2 mos into my MK2, a complete newbie!
Napsal : 17/11/2017 8:33 pm
Re: Prints failing
Try these steps:
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Napsal : 18/11/2017 9:42 pm