Print issues of more than 1 part
I just got my printer assembled on Sunday. I was able to do calibration fine, all good. I did the zig zag test print many times to get test of adhesion with some adjustment of the nozzle. I was able to do some of the prints provided on the card. However yesterday I setup a print that was most of the bed with many parts. I left it to run and when I came home, the print had failed and everything was lifted off the test bed and many pieces of "junk" pla pieces were all over my table my printer sits on. There was some of the pla gummed up on the print pieces. It appears the pieces lifted or a piece lifted and caused the jam.
I was able to print 2 other items latter each individual both came out fine.
Any clue on getting multiple items to print or how to fix this?
Re: Print issues of more than 1 part
.... and everything was lifted off the test bed and many pieces of "junk" pla pieces were all over my table my printer sits on. ...
Any clue on getting multiple items to print or how to fix this?
seems that your first layer (Z-Live adjustment) is still not pristine.
read this thread (at least the first 5 sites).
have a look at the hints about cleaning the printbed as well (and don't touch it with your fingers after cleaning and before printing).
guess it'll help you to find the perfect adjustment and the required adhesion to the printbed.
if it helped you, it would be nice if you'll drop a short note there to keep the thread visible.
dem inscheniör is' nix zu schwör...