Notifications
Clear all
Stránka 2 / 2
Předchozí
Re: New Printer stops after 1hr + LCD corrupts mid progress
Hi Andrew
Thanks for the update and well done for sorting the slicer. Sorry about the problem; I guess it's just one of those things.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Napsal : 11/01/2016 10:37 pm
Topic starter
answered:
Re: New Printer stops after 1hr + LCD corrupts mid progress
Thank you very much for your input Peter.
It helps enormously when someone steps up and helps out with Q&A, which is especially important on a first time Prusa build where there's a desperate need for something to compare against.
A new LCD is being shipped tomorrow and when it's fitted I hope all will be well.
All the best,
Andrew
Napsal : 11/01/2016 11:00 pm
Stránka 2 / 2
Předchozí